Quality welding

We give you a choice between four high-quality cold welders appropriate for welding copper, aluminium and other non-ferrous metals. All the devices work cleanly and quietly and are easy to operate.

CW20
  • For welding round wire produced from copper, aluminium and other non-ferrous metals.
  • Also appropriate for profile wires, e.g. square profiles.
  • Suitability must be verified on a case-by-case basis through samples.
  • Lightweight hand tool for use in hard-to-access locations. Meets industrial standards.
  • No pre-treatment of the welding ends necessary.
  • The welding takes less than a minute.
  • The welding tools are finished precisely by hand and can also be used in the CW2E.
  • Transport and storage case included.
CW10
  • For welding round wire produced from copper, aluminium and other non-ferrous metals.
  • Also appropriate for profile wires, e.g. square profiles. Suitability must be verified on a case-by-case basis through samples.
  • Lightweight hand tool for use in hard-to-access locations. Meets industrial standards.
  • No pre-treatment of the welding ends necessary.
CW3E
  • For welding round wire produced from copper, aluminium and other non-ferrous metals.
  • Also appropriate for profile wires, e.g. square profiles. Suitability must be verified on a case-by-case basis through samples.
  • The machine can be supplied for workbench installation or mounted on a rolling table for mobile deployment.
  • No pre-treatment of the welding ends necessary.
  • The welding tools are finished precisely by hand and can also be used in the CW4E.
  • The welding tools can be supplied up to 3.0 mm in single or dual-channel design.
  • The welding takes less than a minute.
  • Lever extension available, which extends the range up to max. 5.00 mm / 0.1968″ for aluminium or 4.00 / 0.1574″ for copper.
CW4E
  • For welding round wire produced from copper, aluminium and other non-ferrous metals.
  • Also appropriate for profile wires, e.g. square profiles.
  • The machine is supplied mounted on a rolling table for mobile deployment.
  • Compressed air at 4 bar / 60 psi is required for the drive.
  • No pre-treatment of the welding ends necessary.
  • The welding tools are finished precisely by hand and can also be used in the CW3E.
  • The welding tools can be supplied up to 3.0 mm in single or dual-channel design.
  • The welding takes less than a minute.

Technical data: Click here

CW5E
  • For welding round wire produced from copper, aluminium and other non-ferrous metals.
  • The machine is supplied mounted on a rolling table for mobile deployment.
  • Compressed air at 4 bar / 60 psi is required for the drive.
  • Actuation is performed with a foot-operated compressed air valve.
  • No pre-treatment of the welding ends necessary.
  • The machine can pivot for easier operation and access.
  • Developed for welding right-angle profiles; also pivotable.
  • The welding takes less than a minute.

Technical data: Click here